Start Hanging Wallpaper Feature Wall

This has been made simpler because there s no need to apply the paste to the wallpaper fold it and let it soak in before hanging it.

Start hanging wallpaper feature wall.

Plan to lay seams where they ll be the least noticeable. Mix the wallpaper paste with the amount of water that it says on the packet and leave it to stand for a few minutes. Afterward let your new feature wall dry overnight. Hang first strip start at your plumb line and ensure the pattern is right side up.

Decorator for 30 years harry anstice shows you how to wallpaper a feature wall quickly and effectively. Hang wallpaper to create a feature wall hanging wallpaper isn t as complicated as it might seem thanks to new techniques like paste the wall wallpaper. Wallpaper from cole and son wallpapers donated by www. Cut a piece of paper a few inches longer than you need.

Next pull out the tacks and remove excess fabric along the ceiling and corners with a box cutter. Apply the top half of the strip to the wall slightly overlapping the ceiling and adjoining wall. The seam should be exactly on the line and plumb. Hang the first piece to the right of the line and the second piece to the left.

The first length is hung with its edge on the mid point line. Cut from the part of the pattern that matches the paper on the wall around the switch. Remove electrical outlet and light switch covers. When it is time to switch things up use water to dampen one of the fabric s edges and slowly peel off.

If the window is the only feature in the room that you can use as your starting point measure the window and mark the center line. Wash any dirt or dust from the old walls and sand smooth any chipped paint. To avoid unpleasant surprises that result from poor seam placement or having patterns cut off in awkward places don t rush into. Use a plumb line or spirit level to mark a line where you can hang the first piece.

You can use a spirit level instead if you prefer. Apply paste to the plate then lay it face down on the paper. Using a plumb line and pencil mark a vertical line on the wall. Remove old wallpaper using wallpaper remover a wide blade and rags.

Slide the wallpaper into position lining up with the plumb line. Which is the dominant wall. You then continue to hang full lengths either side of this until you reach the corners. Cut a piece of wallpaper larger than the plate.

How to wallpaper a feature wall. Here are the steps to planning for success. Notice that you are left with two narrower lengths in this situation one full length can be cut in half. Although seam planning.